The electric cylinder is a new revolutionary product that realizes the high -precision linear motion series. The electric cylinder is mainly replaced by the cylinder and hydraulic cylinder. The electrical control is more convenient. Do you know about how to maintain and work about the servo electric cylinder?Shaanxi Shuangyu Technology to answer you.

1. When using a servo electric cylinder, lubrication is very necessary.If there is no enough lubrication, the frictional resistance will increase during the operation, which may become the main reason for shortening the life of the product.However, the lubrication method can be roughly divided into manual lubrication and automatic mandatory lubrication.Appropriate choices can be used according to the operation speed of the system and the use environment.

2. The supply frequency of lubricating oil changes according to the conditions and environment of use.Under normal circumstances, it is recommended to supplement grease every 100 kilometers.

3. The servo electric cylinder work every day*, work for 120 days, 180 days, and you must add lubricating fat once.If an abnormal sound is heard at low speed, please contact ABC drive.

4. When the servo motor driver is used for a long time, it should be paid to ventilation and heat dissipation to avoid burning.

How to use the servo electric cylinder correctly?

1. The servo motor cylinder is an integrated product of precision mechanical and electrical.Before use, you should carefully read the precautions and instructions of the motor and drive, and pay attention to use.Without the permission of the electric cylinder manufacturer, the electric cylinder shall not be removed.Especially the screws outside the electric cylinder.

2. The servo electric cylinder is basically a maintenance product. The replacement of any components must be performed at the place authorized by an electric cylinder manufacturer or an electric cylinder manufacturer.

3. A high -intensity synchronous band connection between the servo motor and the servo electric cylinder is adjusted.Therefore, do not disassemble the motor at will, otherwise the operation will be improperly damaged synchronized.

4. When installing, do not apply external torque on the piston rod to avoid damaging the electric cylinder.

5. The servo electric cylinder uses lubricating fat and lubrication, and there is a refueling mouth on the cylinder.When adding, use appropriate lubricating fat and butter guns.The amount and time are: twice (gun schedule)/6 months (or 50 kilometers of schedule)

6. The oil injection method of the screw nut is: After the full stroke of the electric cylinder extend, stop the motor and cut off the power.Open the screws of the cylinder screw oil injection and refuel with a special oil gun.After refueling, install screws, turn on the power, and walk 2 to 3 times throughout the process.

7. When debugging the servo electric cylinder, do it at a low speed first, and then increase the speed after normal aspects, so as not to damage the electric cylinder.

8. ABC electric cylinder is strictly forbidden to contact the sliding seat to maintain the scope of work.

9. When using a roller screw product vertically, it is recommended that the "Z axis" is equipped with a brake device to prevent objects from falling. The gear belt transmission is not recommended to use the "Z axis" vertically.

10. When the effective itinerary is too large, resonance may occur. The larger the journey, the greater the speed.

The servo electric cylinder is different in the industry, and there are non -standard processing. Special requirements of the ABC drive engineers who specially require them. Because the electric cylinder is widely used in many occasions, more and more people will invest in the research and development of the electric cylinder.The electric cylinder will develop towards the direction of accuracy, high loads, high speeds, digitalization and intelligence.